how to operate the generator

1. Select the "MAN" possition of the operation sequence switch. the switch normally at the "OFF" possition.
2. Press the start button. (this will start the generator desel engine)
3. Check, generator output voltage from the volt meter and frequency of supply line. Thies values must be in 415v & 50Hz. If the values are OK goto step 4.
4. Point the manual syn selector to the 1&bus possition.
5. Press the close button of cct braker controle pannel. This will close cct braker contact points & supply power to the "change over switch" Now the meters at the pannel board shows kW rate of the generator
6. Turn ON the chang over switch to the generator supply point. (this will connect the factory supply lines to the generator)